Trench Of Death #2 - Basic Set

1 i want 
i have 

This time a modular trench tile system set.

Unlike the previouse version this set doesn't require the use of XPS foam. Just print, paint, add basing and it is ready to use, to create your trench battlefield.

Each file will recuire an avrage of 90gr / 30meter of PLA. With the standard parameters I used, it takes about 2hours and 45minutes to print, at 300mm/s, 0.2 layer height and with an infill of 5%. So a bit the opposite of the previous fast to print version.

More info on:

Нет описания на русском языке. Любой может его добавить, но пока не дошли руки.


Similar sets


Other sets from this release