Pack Mules

 
i want 
i have 

Mules you’ll receive:
– Bard
– Miner
– Traveler
– Warrior
– Dead
– Unloaded

Mules are not pre-supported!

You can resize the files if you want a smaller (or larger) sized miniatures in your game, these files are
good to 28-32mm miniatures without changes.

You need supports to print these miniatures, we have printed these models at 80-micron and 120-micron layer height, 15 percent infill and 195 C with PLA using a 0.4 mm nozzle (Ender3 pro). These numbers may vary based on your printer and the material you use.

Our support setting in Cura:
Support Placement: Touching Build plate
Support overhang angle: 80
Pattern: Zig Zag

And you’ll need a 6mm brim around the model because legs will release the build plate without it.

Models will be 3.5cm long and around 3 cm high in print.
Set the seed to 30-35mm/s to get better results.

Нет описания на русском языке. Любой может его добавить, но пока не дошли руки.


Similar sets