Skydread Boat

Hoist your sails and scratch your stays, the boats are ready!

Probably the model I am proudest of so far! It's not as ambitious in size as the Cruiser and Dreadnought were, but this time I believe the print-ability and ease of assembly are finally where they should be.

Over are the days of little finicky bits and bobs and scrappy assemblages!

The Skydread Boat comes in only a few big parts: balloon, boat, gun, flight-stand, base. Done!

The pre-supported files are angled very steep and so a whole boat can fit onto a single print-plate, at least if the printer is at least mars3 size (143mm x 89mm). 

In short, even printing several of these should be no headache at all!

Parts included:

• 2 balloon variants 
• 2 hull variants
• 3 per-decorated bases (plus a blank and flight-sticks)
• 2 guns ( cannon and drill )
• pre-supported files for everything