Round Resin Base Insert Display Plinths - 45mm Tall

i want 
i have 

These Round 45mm tall plinths allow for miniatures to remain on their gaming bases and be seamlessly displayed for competition. These designs have a sunken recess for each of the common base sizes. Once inserted your models base will sit flush with a rim of black resin.

We produce plinths for the following round base sizes - 100mm, 90mm, 80mm, 60mm (base measures 65mm), 50mm, 40mm, 32mm, 28mm and 25mm. Each plinth has a 2.5mm rim so will be around 5mm large in diameter than each base. Some sizes have been designed hollow, this serves to reduce weight and aid shipping. Bases will span this hollow section when inserted, hollow plinths are noted in the drop down menu. We recommend using sticky tac or putty to temporally hold your model in place.

Plastic bases can vary in size by a few millimetres depending on manufacturer, we check each casting popular production bases when cast. Paint build up on base rim will affect the fit, and may require you to adjust the rim by sanding the leading edge. Bases not included

The finished height is approximately 45mm once machined, this height can vary plinth to plinth but I always aim to match finished heights across multiple plinths in an order. Cast in strong black pigmented resin. After casting each plinth is machine sanded to ensure the top and bottom surfaces are parallel and true. I inspect each plinth and fill and sand any imperfections, although sometimes I miss things.

Now offering Magnet or Screw inserts for your plinths

PRODUCTION - PLEASE READ!
Due to the amount of resin required to produce these plinths they will be cast to order. This can mean a lead time of up to a week prior to shipping. I would always recommend ordering ahead of time if you require them for a competition. I will always strive to cast items immediately and aim to get orders out the next day. 

Your plinths may arrive in a sanded and prepared state, each and every plinth I cast is meticulously inspected for imperfections these are then filled and sanded out. 

PREPARATION
Prior to use it is recommended to clean each piece is warm soapy water to remove residue release agent. Persistent release and silicone residue will remove with spirit based fluid and an old tooth brush. Wash in water after using spirit based cleaners. If any small bubbles are present they can be filled with superglue applied from a pin tip and sanded back. Always wet sand resin using fine grit wet and dry, sanding from course to fine paper to remove surface marks (240, 320, 400, 600 grit for example). I would always recommend spraying your plinth in a flat coat of black to even out the colour.

DISCLAIMERS
This web store is and its contents are in no way endorsed, or affiliated with Games Workshop Limited. Imperial Knight Dominus Valiant, Imperial Knight Dominus Castellan, Imperial Knight Titan, Imperial Knight Warden, Imperial Knight Paladin, Imperial Knight Errant, Imperial Knight Crusader, Imperial Knight Gallant, Armiger Warglaive, Titanicus and the Warhammer 40,000 name are either ® or ™, and/or © Games Workshop Limited, variably registered around the world. Photographs of existing miniature kits are used only to show scale and compatibility with the accessories found on this page. Used without permission. No challenge to their status intended. All Rights Reserved to their respective owners.

Choking hazard. Not meant for children 16 years or younger.

Every effort is taken to prevent bubbles, although time to time some small bubbles will remain. All measurements are approximate due to resin shrinkage as environmental conditions change during the casting process. Heights are Approximate and can vary each way by a few millimetres. Supplied unpainted

Нет описания на русском языке. Любой может его добавить, но пока не дошли руки.


Similar sets

Add tags to this set to show similars.