Gloomhaven Player Dashboard & Storage Case

 
i want 
i have 

***BEST FOR A FDM (FILAMENT) PRINTER ONLY***

I didn't like any other dashboards around for Gloomhaven, so I made my own. This time, blending both a storage solution, and a comprehensive Dashboard to keep track of all your bits! Check out the link for a video of it in use!

https://www.etsy.com/uk/listing/1036838247/ultimate-gloomhaven-player-dashboard

The MAIN TRAY houses everything from the mini to the tokens, with enough slots and holes to use in any way you feel more comfortable. The player card being used as the table on which you set your cards out as pictured, the two slots either side that act as holders for your discard/lost cards and then the top part of the tray being used for active cards that round. I've created a small dish for the players tokens, a slightly larger one for extra tokens/summons/coins and then 3 slotted recesses for active effects on the player, like muddled or stunned.

The TOP LID slides into place and locks with a slight click to prevent the small pieces escaping, Apply a tiny amount of grease or lube of your choice on the sides and it will slide in perfectly. The lid can also be used to display items, collect coins, hold the modifier deck and also house my custom Health and Experience Tracker www.etsy.com/uk/listing/1020374316.

The PULL OUT MODIFIER DECK is just a simple solution and a place to keep the modifiers, i personally like to place it on the lid after unpacking.

It has by far been one of the best upgrades for Gloomhaven i have made, alongside my custom health counter shown in the pictures. Pull this Dashboard out and be setup in under 30 seconds! The cardboard boxes that the characters come in are fine, but not meant for repeated use.

Three easy to print files and you've got your own dashboard :)
Print the PULL OUT MODIFIER DECK upright, you'll get the best detail and speed out of it.

I print these with a 0.6 nozzle at 0.3 layer height, 0.4 nozzle will be fine too. the TOP LID however i print at a layer height of 0.285 to get an accurate finish.

If you dont have an FDM printer, I sell this physicaly on my Etsy store here:

https://www.etsy.com/uk/listing/1036838247/ultimate-gloomhaven-player-dashboard

 

Нет описания на русском языке. Любой может его добавить, но пока не дошли руки.


Similar sets