Part of the sea, part of the Dredge. Dredge marine warriors are the deadliest power-armoured troops under the seas of the grim future universe. They wear the narwhal pattern power armour, often pocked with barnacles and dripping with slimy sea rot and wield an assortment of dark, sinister weaponry. Some of this weaponry includes the terrifying shark fist, for those particularly blessed by the demons of the deep. Others carry rusted, brutal close combat weapons. Some dredge marines use radioactive melt guns, plasma rifles and tide spitters, but by far the most common is the hammer rifle. Many dredge marines become physically fused to their weapons, for they never let them go. Along with the sea itself, a dredge weapon becomes part of the marine. A dredge marine may opt to take a blood bag – a defeated enemy who is attached to his armour while the marine feeds off it like a parasite. Dredge marines are tough, relentless and they will never stop their inevitable advance.
This multipart set allows you to make as many dredge marines you need, as all parts are interchangeable! The set comes with 133 pre-supported parts, ready for 3d printing. This includes:
- 10 leg sets plus 1 tactical rock
- 5 torsos
- 20 heads (15 narwhal pattern helms, 1 walrus pattern helm and 4 bare heads including an angler fish head)
- 10 double arm sets (including 8 hammer rifles, 1 plasma and 1 melt gun)
- 12 standard single arms (1 is pulling a grenade from his chest bandolier)
- 16 weapon hands (including 1 rifle, 1 tide-spitter, 2 pistol types, 10 brutal hand weapons an empty fist and open palm)
- 2 dredge fists (shark fist and mine fist)
- Powepacks (comprised of 2 powerpack bodies, 10 toppers and 2 guns, each held by a tentacle)
- 33 shoulder pad centres
- 32mm plain base.
Assembly advice: We recommend you dry-fit all parts before gluing, so that you can find that perfect pose, but also so that you can be sure parts will fit nicely. All torsos can rotate in the hip joints, so dry-fit arms onto the torso before gluing the torso to the legs, to make sure the weapons or arms do not collide with the legs. All single hand parts can fit on any arm, however the double arms (the ones holding rifles) are numbered sets. For example, you must place the #3 rifle part with the corresponding #3 arm part. Any shoulder pad centre can go in any shoulder pad slot, on any arm. There is a selection of shoulder pads, some with and some without the dredge legion icon. If you would like to create 10 dredge marines from this set, you must print x2 of each torso and x5 of each backpack body. There are 10 powerpack tops that differentiate the powerpacks and you can attach a tentacle-held gun to any powerpack. All heads and powerpacks are interchangeable with other dredge marine sets. Above all, remember:
Part of the sea, part of the Dredge.
Folder includes both supported and unsupported parts, as well as the LYS file, in case you need to adjust your supports.
