Panzer Iii E Bef 1940

Model representing a Panzer III E of the Panzerregimant 2, 1. Panzerdivision, No.221 In June 1940 France

Panzer III E extremely detailed model with great historical accuracy

DESCRIPTION Panzer III E BEF 1940

The Panzer III Ausf. E saw primary frontline service between 1939 and 1941–1942. The vast majority of these tanks—originally featuring 30 mm of armor—were destroyed, withdrawn from frontline combat units, or converted and modernized (notably rearmed with a 50 mm gun or transformed into command and observation vehicles) between 1941 and 1943, as their 37 mm guns became obsolete. However, some derivative chassis survived and served in secondary or training roles until 1944–1945.

96 units produced between december 1938 and october 1939.

The Panzerbefehlswagen III Ausf. E command variants (often abbreviated as . III Ausf. E or Panzer III E Bef) were built primarily in March 1940, with a total of 45 units produced based on the Ausf. E combat tank chassis.

Armament :

o   3.7 cm KwK L/45 short-barreled gun

o   three MG-34 7.92 mm machine guns

The models :

Model only tested and intended for resin printing at 1/56 scale.
pre-supported model
The models are hollowed out to save resin.
Total weight of the most complete model: 42g
File contents:

Panzer III E BEF 1940

26 unsupported stl files, 26 supported stl files

The 26 stl files contain:

1 hulls
2 turret
2 cupola, 1 open, 1 close
3 left turret hatches: close, open front, open rear, you need mirror for the other side.
4 mudgard, 1 front high and 1 front low, 2 for rear; left and right
11 optional mudguard
3 3 antenna elements—a lower section and an upper section—plus an additional upper section to be completed with wire.
9 optional stowages
1 left tracks, you need mirror it for the second.
1 optional smoke launcher
1 1 antenna hatch
 

This model is for personal use only;

You are not permitted to:

·         Sell STL files

·         Share STL files

·         Redistribute STL files

·         Upload STL files to websites or file-sharing platforms

·         Modify and redistribute STL files

·         Create derivative digital products based on these files

Counlane models.