Retro Siege Tower

90s inspired siege tower for fantasy battles. Designed to be easily printed on an FDM printer with no supports.

This come with optional parts with extra decoration, all of the parts are interchangeable so you can choose which you would prefer to use.

As well as the printed parts you will need a short length of 1.75mm diameter printer filament to use as the axle for the ramp and some string to support the ramp.

When fitting the sting, thread it though the holes in the top piece and ensure that is is around the font pair of hooks un the underside of the top floor.
Then tie it round the mounting points on the ramp (the ramp should be fully fitted to the model before doing this) making sure that when is hangs at this point it is level.
Then when you want to raise the ramp pull the string back and hook it round the rear pair of hooks on the underside of the top floor.
If you have any questions feel free to ask and I will try to help.

All the parts on a print bed with a minimum size of 90mm x 145mm x 160mm