This set contains multiple combinations for short and tall antenna pylons, and a watchtower that can be used as a base support for the antennas or as an independent lookout point.
The models are provided as .stl files and are PRE-SUPPORTED. They have been extensively tested at 6mm scale.
The figures are meant to be printed in 6mm, 10mm (scaling at 140-150%) and possibly in 15mm (scaling at 200-220%). Since the scale of most ranges vary, we recommend users to test with the scaling until they find their preferred scaling settings.
A resin printer is recommended: the models shown in picture are printed at 6mm scale with a Anycubic Photon S. Any budget entry resin printer will be capable to achieve similar results.
